For step 12, see Fig. 3.
12. Before removing the Film Press unit, check if Nylock
®
nuts (M6) are installed on the two
M6x12 socket head pivot bolts. If present remove one nut each from the front and rear
bolts.
NOTE
: Remove the Nylock
®
nuts (M6) from above using a socket wrench. The Film
Press must be in the up (not selected) position to access the nuts. If the right
side Film Press unit is lying flat, the Nylock
®
nuts can be removed from the
bottom side using an open end wrench.
For step 13, see Fig. 2.
13. Remove two of the M4x8 flat-head Philips screws of the Film Press unit Latch Bracket.
CAUTION: do not lose the spacer washers.
For steps 14 - 15, see Fig. 3.
14. Remove the rear M6x12 socket head bolt at the pivot point of the Film Press unit using a
5mm hexagonal wrench. Slide the Film Press unit up and to the rear and off the front
socket head bolt.
Take care not to lose or damage the Film Press unit plastic pivot bushings.
15. Remove the Film Press unit from the main body.
Fig. 3
OMNi-4000 Film Feeder Replacement Manual
4