15 - 22
2-3 Installing
2-3.1 Positioning and mounting
The lubrication unit is attached to the intended
mounting location (3) using appropriate fastening
materials (1). The mounting dimensions of fixing
holes are measured at 205mm. The installation
location should be spaced between 0.6m to 1.7m
above the ground.
Fig.2
2-3.2 Filling Oil
Remove the oil tank cap and fill clean and
non-used oil into the tank and add up to the MAX
mark (Fig. 3). Please note that only use permitted
range of oil viscosity between 30cSt to 250cSt. The
reservoir capacity is available from 3 / 4 / 6 / 8 / 20
liters.
Warning! Motor jammed or burned due to
high resistance which caused by delivering higher
than an oil viscosity of 250cSt.
2-3.3 Lubrication line connection
Solderless tube connection (double tapered
sleeves) can be used. The tube must go through
compressed bushing and double tapered sleeve (See
Fig. 4). To avoid any leaking during running service
time, it should be observed up to 1mm distance
between the tube(4) end to the double sleeve(2). Insert
tube end into counterbored port (3) up to the stop.
First tighten compressed bushing finger-tight by hand.
Then turn another 11/2 turns.
Fig.3
