Iseo MDC IS9100, Инструкция по монтажу

Страница: 4 / 28

IS9100
—
MDC
4 ISEO
Fix the opening piston inside the respective hole of the
coupling piece in accordance with the prevailing way of
mounting.
Remove the PCB with the internal program switches from
both operators.
First remove the connection cable
➀
, then move the PCB
upwards and pull it out
②
.
Fix the reset spring unit on the face side of the system girder
with screws.
Ensure that pressure plate
« A » is in the correct position.
Insert the rod for the active leaf (GF) from the face side
through the remaining hole in the pressure plate into the
respective openings of the system girder.
You can distinguish the rod for the active from the rod for the
passive leaf
(SF) as follows :
The rod for the passive leaf is longer and has an additional
groove.
Use an open end spanner to fix the rod until it locks in
position inside the coupling piece.
Connect again the flat ribbon cable on user interface side
GF
SF
13 mm
9 mm
5
1
2
6
A
Torx T20
4 mm
7
8
9