14
isel
-CNC Compact Equipment CPM
Tooling machine
(only in the case of type 3)
In the collet
, the standard tooling machine can take tools with a maximum shaft diameter
of 6.35 mm (standatd 3 mm, other diameters see Accessory). Use the sickle spanner and the
spanner SW 17 open end wrenches for changing the collet.
The current for the tooling machine is only enabled by
the software. You can manually adjust the rotation
speed of the machine using the
wheel.
Switch off the main switch of the CPM for dismantling
the tooling machine. Remove the electricity cable from
the coupler terminal block, loosen the clamping screw
and take the tooling machine from the holder.
For dismantling the machine with the holder, remove
the electricity cable, the two outside screws
(loosen only, do not screw very out) and remove the
machine with holder and T-slot stones downwards.
Using corresponding holders, you can also attach many
other tools, measuring instruments (laser), or other
suitable equipment to the T-slot plate of the Z-axis.
Use the branch box at the Z-axis for the electrical connection.
If you want to mount the tooling machine or other tools again, you must realign the holder
parallel to the XY-plane.
