Iseki TXG237, Руководство по эксплуатации

Страница: 63 / 98

TXG237
62
FIG. 5-21
FIG. 5-22
COOLING SYSTEM
CAUTION: DO NOT remove radiator cap
when engine is hot.
Rotate cap slowly to release pressure. Then cap can
be safely removed.
FIG. 5-21: Cooling system is filled at factory with anti-
freeze solution to protect engine and radiator to -34°C.
Coolant level should be maintained to 12mm below
the filler neck opening, 1. Check coolant protection
from freezing annually.
NOTE: After adding coolant, start engine and oper-
ate until thoroughly warmed so coolant is
mixed. Periodically check level of coolant
in overflow reservoir to make sure level is
located between marks when engine is cold.
Periodically check condition of hoses, belt and clamps
and tighten of replace as necessary.
Keep radiator, radiator screen and hood screens clean
to permit maximum cooling.
IMPORTANT: Use care when cleaning radiator to
prevent cooing fin damage.
FIG. 5-22: Drain cook, 2, will drain coolant from
cylinder block and radiator. Drain cook is located on
left side of engine. Coolant should be replaced if it
becomes contaminated with rust or sludge. Loosening
radiator cap will assist draining.
NOTE: When coolant is replaced, flush inside of
radiator and engine block with clean water.
Radiator and engine must be drained if freezing tem-
peratures are expected and cooling system is not filled
with coolant having adequate protection from freezing.
1
2
2