Iseki SXE213H95, Инструкция по эксплуатации

Страница: 41 / 80

GB
Start-up
41 4 42138_a
Filling the tank
1. Switch off the engine if it is running and re-
move the ignition key as a precaution.
2. Wait until the engine has cooled down so-
mewhat (risk of explosion if the fuel catches
fire!).
3. Press the tank cap cover (8a).
4. Swivel the tank cap cover (8a) up.
The tank cap cover (8a) is unlocked.
5. Open the tank cap (8b) and pour in the fuel.
CAUTION!
Avoid overfilling the fuel tank!
6. Close the tank cap (8b).
7. Close the tank cap cover (8a) so it engages.
Checking the tyre pressure
Check the tyre pressure at regular intervals.
Please refer to the tyre for the necessary in-
flation pressure (recommendation: 1 bar).
ADVICE
1 PSI = 0.07 bar.
The tyre pressure can be checked and the tyre
inflated using a commercially available foot pump.
Mounting the grass catcher
Lawn tractors are supplied with a grass catcher.
Please note that the illustrations may differ so-
mewhat from the original.
Hooking in the fill-level sensor of the grass
catcher
The fill-level sensor uses a horn to signal when the
grass catcher must be emptied. The grass catcher
must be removed in order for the fill-level sensor
to be fitted.
The fill-level sensor (9a) must be pushed into the
opening in the rear wall. Make sure the fill-level
sensor is in the correct position. Push it into the
opening straight and without excessive force, until
you can feel it engage.
Hooking in the grass catcher
1. Hold the grass catcher with one hand on the
catcher handle (10b) and your other hand on
the holding opening at the back (10b).
2. Place the grass catcher symmetrically onto
the guide (10c).
3. Use your other hand to tip the grass catcher
slightly forward (11) so the front part of the
grass catcher engages.
4. Now swivel the grass catcher back down
(12a).
5. Check the grass catcher is correctly seated.
Checking the safety devices
Check the safety devices each time before the
lawn tractor is started.
WARNING!
Danger when checking the safety de-
vices!
The safety devices are only allowed to
be checked from the driver's seat, and
when no other persons or animals are in
the vicinity!
Carry out all checks on level ground so that the
lawn tractor cannot roll away inadvertently.
Checking the brake contact switch
The brake contact switch ensures that the engine
cannot be started if the brake is not applied.
1. The engine is off.
2. Sit on the operator's seat.
3. Release the parking brake by pressing the
brake pedal (4a).
4. Attempt to start the engine (ignition key in po-
sition III).
CAUTION!
The engine is not allowed to start!
Checking the mower mechanism contact
switch
The mower mechanism contact switch ensures
that the engine cannot be started if the mower me-
chanism is activated.
1. The engine is off.
2. Sit on the operator's seat.
3. Press the brake pedal (4a) and the parking
brake (4b).
4. Switch on the mower mechanism.
5. Attempt to start the engine (ignition key in po-
sition III).
CAUTION!
The engine is not allowed to start!
Checking the seat contact switch
The seat contact switch ensures that the engine
switches off as soon as there is no-one on the
operator's seat when the mower mechanism is
switched on.