Iseki SBC550X, Руководство по эксплуатации

Страница: 77 / 105

SCMA54&SCMB48
76
III. MOWER OPERATION
b. Select one of the setting holes to get the required cut-
ting height, insert the pin, and retain it with the spring
clip pin. The label showing the relationships between
the setting holes and cutting heights is stuck on the
mower deck.
c. Also set the cutting height of the gauge wheels by
re-setting the setting hole for the setting pin with the
spring clip pin removed.
d. The right and left gauge wheels should be set to the
same cutting height.
e. Move the lift lever forward (
d
) to lower the mower
deck.
CAUTION: Before operating the lift lever, be
seated in the operator’s seat and make sure
of the safety conditions when lowering the
mower deck.
3. HEIGHT ADJUSTMENT DIAL
The use of height adjustment dial can reduce the mark
of gauge wheel on ground when cutting grass on soft
ground. (Refer to page 39)
• How to use the height adjustment dial
a. Move the lift lever backward to raise the mower deck
to most highest position.
1. BEFORE OPERATION
CAUTION:
• Before starting the mower operation, be
sure to eguip ISEKI standard grass col-
lector. Never mow grass without the col-
lector or the lawn mower scatters grass,
stone and other flying debris, which is very
dangerous.
• Become familiar with the operation of the
lawn mower, and understand safety in-
structions by reading this manual carefully.
• Make sure that all safety covers and guards
are installed in position.
• Make sure that the blade nuts are tight-
ened securely.
• Make sure that the belt is tensioned evenly
as specified.
• Before moving the lawn mower into the
working site, check the whole area and get
rid of all obstacles such as stones, wood,
empty tins, bottles, wires, etc to assure
safe operation.
• Make sure that the mower operation will
not cause any injury to children, animals,
bystanders, or damage to trees, build-
ings, etc.
• Check the place to mow for bumps, ditch-
es, mounds, steps, slopes, inclination,
softness, water pools, etc. ahead of time
to avoid accidents such as turnover, fall,
side-sliding of the lawn mower.
2. CUTTING HEIGHT ADJUSTMENT
(1) Spring clip pin
a. Start the engine. Move the lift lever backward (
u
) to
raise the mower deck, and then stop the engine.