ISA ZERO TOUCH T12, Руководство по эксплуатации и обслуживанию

Страница: 18 / 72

18
EN
428000729 137
USE AND MAINTENANCE MANUAL
ZERO TOUCH
6.6 FIRE
Danger
In the event of a fi re, immediately disconnect the master switch from the main power supply line.
6.7 EXPLOSIVE ATMOSPHERE
The equipment must not be located in an area classifi ed as an explosion risk according to 1999/92/EC
such as:
Zone 0
An area in which there is a permanent, long-lasting or frequently explosive atmosphere made up of a
mixture of air and fl ammable substances in the form of gases, fumes or steam.
Zone 1
An area in which the formation of an explosive atmosphere, made up of a mixture of air and fl ammable
substances in the form of gases, fumes or steam is occasionally probable during normal activities.
Zone 20
An area in which there is a permanent, long-lasting or frequently explosive atmosphere in the form of
clouds of combustible dust in the air.
Zone 21
An area in which the formation of an explosive atmosphere in the form of clouds of combustible dust is
occasionally probable during normal activities.
6.8 SLIPPING
Any leaks in the areas surrounding the appliance may cause personnel to slip.
Check that there are no leaks and keep these areas clean at all times.
6.9 TRIPPING
Generally untidy deposits of material may constitute a tripping hazard and a total or partial obstruction
of emergency exit routes.
Ensure that operating and transit areas and emergency exit routes are free from obstacles in
compliance with current legislation.
6.10 CIRCUIT FAULTS
Owing to potential faults, safety circuits may become less effective, which results in lower safety levels.
You should check the operational condition of the appliance devices regularly.
6.11 WARNING SIGNS
(IF ANY)
The appliance is fi tted with warning danger, warning and obligation signs defi ned in agreement with the
Standard relative to the graphical signs to be used on plants.
The signs are located in clearly visible positions.
Attention
The warning plates present on the appliance must not be removed.
The user is responsible for replacing warning signs that, owing to wear, become unreadable.
6.12 FALLING OBJECTS
Positioning of the cabinet display parts (i.e. counters, rods and hooks), as also product arrangement
inside the cabinet can be the source of potential hazards if not properly performed.
Follow the positioning instructions described in this Manual before you place products inside the
cabinet, check that the counters are properly fastened, as also the hooks, etc. Do not exceed the
maximum load limit. Do not tilt the shelves. Do not place any goods and in general, do not load the
tank sliding element closing devices with any load, while open or closed.
Do not place any goods and in general, do not load the tank sliding element closing devices
with any load, while open or closed.