ISA METRO RV LS 93, Руководство по эксплуатации и обслуживанию

Страница: 10 / 38

10
METRO’
USE AND MAINTENANCE MANUAL
428000375 237
EN
PASTRY DISPLAY CABINETS
4. INSTALLATION
This manual provides information on how to unpack,
position and connect to the power supply.
4.1 Storage and unpacking
The equipment, with or without the packaging, should be carefully stored inside warehouses
or in areas away from the elements and direct sunlight, at a temperature between 0 and
+40°C.
The equipment should only be moved by qualifi ed personnel operating forklift trucks, the
power of which should be suited to handling the weight of the product: during this operation
the equipment MUST be placed on the special pallet supplied.
Unpack the equipment by removing the screws fi xing it to the pallet.
All packaging materials are recyclable and should be disposed of in accordance with local
regulations. Please destroy "plastic" bags to prevent them from becoming hazardous to
children (suffocation).
4.2 Installation, positioning and ambient conditions
Attention
There should be a good air fl ow around the compressor and condensing unit. Therefore the area
around the unit should not be obstructed by boxes or other objects.
Position the equipment away from sources of heat (radiators, all types of ovens, etc.), and away from
draughts (generated for example by fans, air conditioning ducts, etc.).
Also avoid direct exposure to sunlight, or anything that causes the temperature inside the cabinet to
rise with detrimental results to unit operation and energy consumption. Do not use the equipment
outdoors and do not leave it exposed to rain.
4.3 Electrical connection
Attention
Check that the voltage indicated on the appliance is the same as the value on the appliance
identifi cation label and in the table provided in paragraph 2 of this manual, and check that the
required voltage is suitable.
Check on the socket that the power supply voltage provides rated voltage (±10%) when the
compressor is started.
The plug should be directly connected to the electrical socket. It is forbidden to connect the plug to
the socket by means of multiple socket extensions or adaptors.
The electrical system socket must be fi tted with a disconnecting device from the mains (rated for the
load and conform to current standards) to guarantee full disconnection in overloads category III (3)
and ensure protection of the circuits from earth faults, overloads and short circuits.
Do not route the electricity cable in passageways.
Attention
Earthing is necessary and mandatory by law.