Page of 12
6
Maintain tools with care. Keep Cutting tools maintained and clean. Properly maintained tools
are less likely to bind and are easier to control. Do not use a damaged tool. Tag damaged
tools <<Do not use >> until repaired.
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when used on another
tool.
OPERATION
Following all safety requirements already listed, plug the power cord into a circuit breaker
protected 120V, 60Hz power outlet.
WARNING:
Do not turn on the tool until you have read this entire manual, and follow all
safety information, notes, cautions and warnings provided.
To turn on the tool, slide the power switch (38) forward to the ON position. The upper shear blade
(12) will begin to move up and down at high speed.
NOTE: It is a good idea to make a few practice cuts on scrap material before cutting your work
piece.
To cut material, fit the tool rest (1) over the edge of the material, and move the tool slowly forward
along the desired cut line of the material. As the upper shear blade (12) moves up and down
against the lower shear blade (2), the material will be cut.
WARNING:
The edge of sheet metal is very sharp. Always wear protective gloves when
handling sheet metal.
CAUTION:
Do not cut across a welded seam as this might damage the blades.
To stop cutting, slide the power switch (38) back to the OFF position. Unplug the tool.
