background image

3

IMPORTANT SAFETY AND WARNING 

INFORMATION

READ THIS MANUAL IN ITS ENTIRETY AND UNDER-

STAND THESE RULES TO FOLLOW FOR SAFETY.

1.  When this room heater is not properly installed, a house fire 

may result. To reduce the risk of fire, follow the installation 

instructions. Contact local building or fire officials about 

restrictions and installation inspection requirements in your 

area. 

2.  Wear gloves during installation to avoid injury from sharp 

edges on the stove and/or its parts.

3.  This unit is designed and engineered to burn only dry, well-

seasoned wood. Burning wet wood will greatly reduce your 

stoves efficiency, produce excessive amounts of smoke and 

can cause dangerous chimney fires due to creosote build-up.

4.  Before opening the door, the 

draft control must be fully open 

to avoid possible combustion flash 

(ignition of hot volatile 

gases as the door is opened).

5.  Never use gasoline, gasoline-type lantern fuel, kerosene, 

charcoal lighter fluid, or similar liquids to start or ’freshenup’ 

a fire in this heater. Keep all such liquids well away from the 

heater while it is in use. 

DO NOT USE CHEMICALS OR FLUIDS 

TO START THE FIRE.

6.  While burning, fuel utilizes oxygen from the air in the room. 

Be sure to allow an adequate amount of fresh air into the 

room where the stove is burning.

7.  The outside surface of the stove will be hot while burning 

properly and can set items like clothing and curtains on fire. 

Keep furnishings and other combustible materials away from 

the stove. Using the heat from the stove to dry wet clothing 

can be hazardous if clothes are placed too near the surface 

of the stove.

8. 

HOT WHILE IN OPERATION. KEEP CHILDREN, CLOTHING 

FURNISHINGS AND COMBUSTIBLE MATERIAL A CONSID-

ERABLE DISTANCE AWAY. CONTACT MAY CAUSE SKIN 

BURNS.

  Do not allow children to play near the stove without 

close supervision. Do not touch the stove while it is burning. Use 

extreme caution while the unit is in use. Surface temperatures 

become dangerously hot and can cause serious burns. 

9.  Do not allow anyone to operate the stove who is not familiar 

with the operating instructions.

10.  Attempts to achieve heat output rates that exceed stove design 

specifications can result in permanent damage to the stove. 

Never leave your stove unattended on high burn rates. This 

may cause overfiring. Overfiring the stove may cause a house 

fire. 

If the stove glows, you are overfiring.

11.  Keep a water hose or hand-operated fire extinguisher close 

for safety.

12. 

Smoke Detectors

 - Since there are always several potential 

sources of fire in any home, we recommend installing smoke 

detectors. If possible, install the smoke detector in a hallway 

adjacent to the room (to reduce the possibility of occasional 

false activation from the heat produced by the stove).  If your 

local code requires a smoke detector be installed within the 

same room, you must follow the requirements of your local 

code. Check with your local building department for require-

ments in your area.

13.  Inspect your chimney at least once a month during the burn-

ing season to check for soot and creosote accumulations. 

Any accumulations over 1/8” thick should be removed by a 

professional chimney sweep. Do not attempt to burn out heavy 

creosote accumulations with a hot fire. If large accumulations 

are occurring, review your burning procedures.

14.  If a creosote fire should develop, the fire department should 

be called immediately and then attempts should be made to 

control the fire until assistance arrives. If a “runaway” fire 

should develop causing over-heating of the stove, the door 

and draft regulators should be closed immediately. The fire 

should die down once deprived of oxygen. After a severe 

chimney fire, the complete chimney system should be checked 

before further use.

15.  Do Not Use Grate Or Elevate Fire - Build Wood Fire Directly 

On Hearth (firebrick). Do not use andirons or other methods 

of supporting the fuel.

16. Please read this entire manual before you install and use your 

new room heater. Failure to follow instructions may result in 

property damage, bodily injury, or even death.

17.  Check all local building and safety codes before installation. 

The installation instructions and appropriate code require-

ments must be followed exactly and without compromise. 

In the absence of local codes the following standards and 

codes must be followed.

18.  In the U.S.A, install in accordance with the National Fire 

Protection Association’s Code, NFPA 211, Standards for 

Chimneys, Fireplaces, Vents and Solid-Fuel-Burning Appli-

ances, or similar regulations, may apply to the installation of 

a Solid-Fuel-Burning appliance in your area. In Canada, the 

guideline is established by the CSA Standard, CAN/CSA-B365-

M93, Installation Code for Solid-Fuel-Burning Appliances and 

Equipment.

19. 

DO NOT CONNECT TO OR USE IN CONJUNCTION WITH ANY 

AIR DISTRIBUTION DUCTWORK UNLESS SPECIFICALLY 

APPROVED FOR SUCH INSTALLATIONS.

20. 

WARNING: BURNING IMPROPER FUEL (I.E. CHARCOAL) 

CAN RESULT IN CARBON MONOXIDE POISONING, WHICH 

MAY LEAD TO DEATH!  

21. 

Carbon Monoxide Poisoning

 – Early signs of carbon monox-

ide poisoning resemble the flu with headaches, dizziness, or 

nausea.  If you have these signs, get fresh air at once!  Have 

the heater inspected by a qualified service technician.  Some 

people are more affected by carbon monoxide than others.  

These include pregnant women, people with heart or lung 

disease or anemia, those under the influence of alcohol, and 

those at high altitudes.

22.  Failure to use manufacturer provided parts, variations in tech-

niques and construction materials or practices other than those 

described in this manual may create a fire hazard and void the 

limited warranty.

23.  Do not make any make-shift compromises during installation. 

Any modification or alteration may result in damage to the 

appliance or dwelling and will void the warranty, certification 

and listings of this unit.

24. These appliances are designed as supplemental heaters. 

Therefore, it is advisable to have an alternate heat source 

when installed in a dwelling.

25. 

Do Not Overfire – If Heater or Chimney Connector Glows, 

You Are Overfiring.

26. 

DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERV-

ING ANOTHER APPLIANCE.

27.  

DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS SUCH 

AS GASOLINE, NAPHTHA OR ENGINE OIL.

Содержание Canyon ST310

































Отзывы: