STEP FIVE:
Attach the TOP CENTER/CROSSMEMBER assembly to the SPINE/SLIDE RAILS.
Locate the following parts: 2x 1/2 inch x 100mmbolts (separately packaged in the bolt pack) and 2x
M12x180mm bolts/2x M12 washers and 2x nylock nuts.
Prepackaged 1/2 inch” x 100mm bolts
for CROSSMEMBER into SLIDE RAIL
Lift TOP CENTER assembly up onto the SLIDE RAILS and SPINE.
CROSSMEMBER TO SLIDE RAIL will use the 2x 1/2” x 100bolts. Use
the same Allen wrench provided for STEP 2 of the assembly.
Rear of TOP CENTER Bolts to SPINE using 2x M12 x 180mm bolts.
CAUTION: 2 People are strongly recommended for ease of alignment
and to avoid possible injury.
TIP: Don’t tighten until you are sure that the SLIDE RAILS have not
moved, and the entire assembly is square. Slide the LIFTING BAR up
and down the SLIDE RAILS. It should not bind, and the safety hooks
should locate in the same position on both sides of the SLIDE RAILs prior
to tightening the assembly. This may take a few tries.
Once you have determined fit and function are correct, move the LIFTING
BAR to the highest position on the SLIDE RAILS and tighten all four bolts
Once the assembly is complete find the SILICONE SPRAY (included)
and generously apply to both SLIDE RAILS.
TOP CENTER/CROSSMEMBER
assembly
