8
STEP 6
STEP 8
A
.
After everything is square, make sure all nuts on the
system have been tightened.
NOTE: But do not over tighten the Nuts, make sure the unit
can be adjusted up and down.
B. To apply the Rim Height Sticker(H), first use a tape
measure to crank rim up to exactly 10’ from the playing
surface. Use a pencil to make a mark on the Spring-assist
Cartridge(E) where the bottom of the Rim Height Indicator(G)
stops. Then, peel and apply Rim Height Sticker(H) to outside
of Spring-assist Cartridge(E) lining up the pencil mark with the
10’ mark on the Rim Height Sticker(H).
C. Attach Post Pad and Gusset Pad to Main Post(A) as shown.
A. Attach the backboard to Main Extension Arm(B) by
using a 18mm x 415mm Hex Bolt(W), two 18mm Flat
Washers(U) and a 18mm Lock Nut(M).
B
.
Attach
the 2
Upper Extension Arm(C) to Backboard
frame
,
be
sure
the
longer
welded
tubes
at
the
end
of
upper
arms
face
to
backboard
frame
as
shown
,
using a 18mm x 345mm Hex Bolt(W), two 18mm
Flat Washers(U) and a 18mm Lock Nut(V)
to
tight
the
upper
arms.
A. Insert the 4 Plastic and Steel Spacers(M) into the 4
holes on the backboard.
CAUTION: Do not proceed with rim installation
without these spacers!
B. Mount the rim to the H-frame Backboard Mount(D)
and Backboard Assembly using the hardware supplied
in rim box.
NOTE: Use a level to make sure rim is level side to side
before tightening nuts.
STEP 7
M
H
U
U
V
The
2
longer
sides
face
to
backboard
frame
.
Face
to
post
.
Upper
extension
arms
T
U
U
V
W
