Tools and materials required for assembly
1. Hammer or Mallet
8. Concrete 9 Bags (80lbs/bag).
2. Two Adjustable Wrenches
9. Electric Drill
3. 9/16" Wrench
10. Carpenter’s Level
4. 3/4" Wrench
11. A minimum of two Ladders
5. 11/16" wrench
12. Water Supply
6. 1" Wrench
13. Tape measure
7. Shovel
THREE PEOPLE ARE NEEDED TO ASSEMBLE THIS UNIT
Day 1
INSTALLATION (Day 1 to Day 4)
Prior
to
anchor
system
and
goal
assembly, call
utility
services
for
location
of
underground
utility
lines
before
you
dig.
This assembly needs 5 days totally.
Day 1
: Anchor system installation.
Day 2-4
: Allow concrete to cure.
Day 5
: Complete basketball system installation.
Locate your system close to or on the court. Dig
a hole as shown in figure 1. Bell out the bottom.
Assemble anchor system as shown in fugure2:
Thread nut M16 (U4) all the way to bottom of
threads on J-bolt (U2) insert threads of J-bolt
(U2) through hole on anchor plate (U1) and
secure with nut (U4).
Note: Each leg of anchor bolts should face
the anchor bolt to the right. See Figure 2.
Mix and pour concrete into hole.
follow instructions on concrete
bag. Stop about 8" below playing
surface.
Insert 4 Rebars (U5) into concrete
8" apart making a square in center
on hole.
Continue to pour concrete into hole.
Use a concrete form or wooden form
for top 4", until concrete flush with
playing surface.
Push anchor system into concrete and
agitate to eliminate voids in concrete,
level and square anchor plate (U1) to
playing surface. Clean off any concrete
on anchor plate and exposed threads.
You are finished with anchor system.
Allow concrete cure a minimum of 72hrs.
Warning
Never continue to assemble your
system without following cementing
instructions. Failure to do so may
cause serious personal injury or
property damage.
U1
U4
U4
U2
16" Dia
36"
1.
2.
5.
3.
4.
Figure2
Figure1
U5
4
Play surface
Anchor system installation
Содержание GC66-XXL
Страница 8: ......
