Ironclad FCH-885, Инструкция по сборке и руководство пользователя

Страница: 8 / 8

8
STEP 6
STEP 8
A . After everything is square, make sure all nuts on the
system have been tightened.
NOTE: But do not over tighten the Nuts, make sure the unit
can be adjusted up and down.
B. To apply the Rim Height Sticker(H), first use a tape
measure to crank rim up to exactly 10’ from the playing
surface. Use a pencil to make a mark on the Spring-assist
Cartridge(E) where the bottom of the Rim Height Indicator(G)
stops. Then, peel and apply Rim Height Sticker(H) to outside
of Spring-assist Cartridge(E) lining up the pencil mark with the
10’ mark on the Rim Height Sticker(H).
C. Attach Post Pad and Gusset Pad to Main Post(A) as shown.
A. Attach the backboard to Main Extension Arm(B) by
using a 18mm x 215mm Hex Bolt(W), two 18mm Flat
Washers(U) and a 18mm Lock Nut(M).
B
.
Attach the 2 Upper Extension Arm(C) to Backboard
,
using a 12mm x 35mm Hex Bolt(AA), a
P
lastic
Washer
(
AD
) ,
two 12mm Flat Washers(AB) and a
12mm Lock Nut(AC) to tight the upper arms.
C
.
Tight the other Upper arm by repeat step B
.
A. Mount the rim to Backboard by using the hardware
supplied in rim box.
NOTE: Use a level to make sure rim is level side to side
before tightening nuts.
STEP 7
H
AB
AB
V
W
U
U
AA
AC
AD