IronAir TTD1146OF, Руководство по эксплуатации

Страница: 9 / 16

9 OPERATING MANUAL
SETUP
1. Connect your air supply hose to a 1/4” (6mm) male universal or industrial quick connect
coupler to the female quick connect coupler located on the air compressor.
2. Make sure the drainage valve is closed and that the pressure switch is in the off position.
3. Ensure that the power supply you are going to use is operating normally.
4. Insert the power supply cord into the power supply socket and turn on.
5. If using for the first time perform a Test Run.
TEST RUN
Before using the air compressor for the first time, complete a test run as follows.
1. Start the air compressor by moving the pressure switch to the ON position.
2. The pressure gauge reading will slowly rise as the pressure increases inside the tank. When
the gauge reading reaches 8bar, the pressure switch will automatically turn the power off.
This indicates the compressor is working normally.
3. If, when the air compressor is first turned on the pressure gauge reading does not increase
check for air leaks. Air leaks can usually be found in the regulator cup, drain valve and
connection points.
4. Turn the pressure switch to the OFF position, unplug the power supply cord and release
the air in the tank by pulling on the safety valve. At this point proceed to the next step
(daily operations).
Note: If the air compressor is not working properly the pressure gauge will indicate there is a
decrease in the pressure in the air tank. If there is an air leak from the compressor the pressure
in the air tank will decrease, the pressure switch resets and the motor automatically turns back
on. If you detect an air leakage, turn the power switch on the OFF position, release the air from
the tank by pulling on the safety valve. Unplug the power supply cord and contact the place of
purchase.