Copyright 2021 Iron Bow Technologies
30
Appendix.2. – Tethered Remote Volume Control
The MedView is often used in an environment where it is
wall mounted above a display and is set to auto answer an
incoming call. In this configuration, there may be a
requirement for the volume level of the system to be adjusted
within the room.
The Tethered Remote Volume control has a volume up and
down button, which when pressed, raises or lowers the
volume until the button is released. A volume indicator bar is
displayed on the top right hand side of the screen showing the
volume level when either of the + or – keys are being pressed.
As the Volume control is tethered and uses a Tactile
Membrane panel, it does not require batteries, is not easily
lost or misplaced and can easily be cleaned.
Connecting Tethered Remote Volume Control to MedView System
The Tethered Remote Volume Control is connected to the USB
2 port on the rear of the MedView system, as shown in Figure
28.
Camera Reset Function
In locations where the MedView system is mounted at high
level when the system is being cleaned, it is possible that the
camera can be jolted out of position such that it is not aware of
where it is pointing. In this event, the camera can be reset by
selecting and Holding both the and Volume –
buttons simultaneously for 5 seconds. The camera will then go
through a short reset routine and resume normal pan/tilt
operation.
Figure 24 – Tethered Volume Control
Figure 25 – Connecting the Tethered
Remote Volume Control
Figure 26 – Camera Reset
