Copyright 2018 Iron Bow Technologies
9
Getting Started
Powering On and Off
The CLINiC control panel, display, camera and codec will automatically power on when
connected to AC power.
The CLINiC codec has a power sensor that can be used to power the codec on and off
individually from the rest of CLINiC components, although that is typically not
necessary.
The CLINiC codec power sensor is located behind the display on the top of the codec
enclosure, as shown in the following figure.
Figure 6. CLINiC 2x rear view with codec power sensor
Powering On the CLINiC
Connect the peripherals to the HDMI and/or VGA ports of the CLINiC before connecting
the CLINiC to AC power.
To power on the CLINiC:
Connect the CLINiC to AC power. This will automatically power on the codec,
camera, display and control unit of the CLINiC. A splash screen is displayed
within several seconds.
NOTE: If the display goes to power-saving mode and a splash screen is not displayed,
you will need to separately power on the codec. This could happen because the codec was
previously powered off using the power sensor. Whenever you power off the codec using
the power sensor, you will need to touch the power sensor to restart it.
To separately power on the CLINiC codec:
Touch and hold the power sensor. A splash screen is displayed within several
seconds.
