Iron Baltic 86.1000, Инструкция по безопасности и эксплуатации

Страница: 20 / 44

20
Samm 3 Paigaldage raami toru (Pos.2) sillatala külge. Jälgige, et raami torus olev tapiava (tiisli
toru kinnitusava) (drawbar mounting hole) oleks maapinna suhtes vertikaalselt ja
asuks haagise esiosa (FRONT) pool! Kui kasutate haagist metsaveo haagisena
paigutage sillatala võimalikult veetava koorma keskele. Kui kasutate haagist koos
veokastiga on sillatala õige asukoht 1085 mm raamitoru esiservast. Fikseerige raami
toru asend M12x30 poltidega (Pos.21) ja lukustage poldid M12 mutritega (Pos.27).
Step 3 Install frame tube (Pos.2) to axle beam. Make sure that the pin hole (drawbar
mounting hole) in the frame tube is vertical to ground and is on the front side of
trailer! If you are using the trailer as timber trailer then place the axle beam in the
middle of the expected load to be carried. If you use trailer with a cargo box, the
position of the axle beam is 1085 mm from the front edge of the frame tube. Secure
frame tube position with M12x30 bolts (Pos.21) and lock the bolts with M12 nuts
(Pos.27).
Drawbar
mounting hole
2
21 27
4x
1085 365
FRONT REAR
Samm 4
Paigaldage tagumine kandur (Pos.4) raami toru peale selliselt, et kanduri tagumine
serv oleks raami toru servaga tasa. Jälgige, et veokasti kinnitusavad (cargo box
mounting holes) oleksid haagise tagaosa (REAR) pool! Kinnitamiseks kasutage 70x70
U-polte (Pos.7), Ø10 mm seibe (Pos.25) ja M10 nyloc mutreid (Pos.28).
Step 4 Install rear carrier (Pos.4) to frame tube so that the edge of the carrier is equal to edge
of the frame tube. Make sure that cargo box mounting holes are on the rear side of the
trailer. For fastening use 70x70 U-bolts (Pos.7), Ø10 mm washers (Pos.25) and M10
nyloc nuts (Pos.28).
Veokastiga haagis / Trailer with cargo box