Iron Baltic 86.1000, Инструкция по безопасности и эксплуатации

Страница: 16 / 44

16
•
The highest speed when transporting a load is 20km/h, or what the vehicle manufacturer
recommends (the lower speed must be observed).
•
Apply the ATV parking brake before working with crane.
•
Make sure that the support legs are on hard, level ground and locked in, before operating with
crane.
•
When installing fasteners to load for lifting, take into account the centre of the gravity of load.
Stop lifting at a height of half a meter and check the balance of the load.
•
When lifting, make sure that the load cannot slip on the lifting ropes.
•
Do not start lifting unless you are sure of the strength of the connection.
•
Do not exceed the maximum capacity of the crane.
•
When installing cargo box with crane on a trailer:
1. Stop the trailer as close to the side of the cargo box as possible
2. Apply the ATV parking brake.
3. Set drawbar length to length L1.
4. Fix the crane support legs to a hard and level surface.
5. Set the crane boom to the highest position and remove the pin that restricts lateral
movement.
6. Attach the 4-prong lifting strap to the lifting points on the cargo box.
7. Start lifting, if necessary, guide the movement of the cargo box by hand.
NB! It is forbidden to lift the cargo box with a load in it!
8. Fix the cargo box to the rear carrier with pins.
•
When using cargo box, make sure that the box clamp is locked before loading the load.
•
To tilt the load from the cargo box, apply the ATV parking brake, open the box clamp and lift
the box.
•
When tilting the cargo box with a crane, use the highest crane boom position and the shortest
boom length.
Prefer to use the lifting adapter in front of the box and use the lifting point inside
the box only when necessary.
12. MAINTENANCE
•
Always wash the trailer after use. To remove most of the dirt, use running water. Usual car
shampoo can be used for washing the trailer.
•
Only change trailer tire on flat and hard surface, by placing jack stand under the vertical axle
beam corner.
•
If the tow coupling moves difficultly, add oil to places showed on the diagram or contact
manufacturer or licenced reseller.
Maintenance activity: Before and
after work
Weekly Monthly Seasonally
Clean the trailer
● ● ● ●
Tire pressure, wheel bolts, tow coupling connection check
● ● ● ●
Visual inspection of parts fastening
● ● ● ●
Checking the condition of all connecting parts
● ● ●
Inspection of safety labels
● ● ●
Lubricate the tow coupling and swing arms
● ●
Checking the wear rate of metal parts
● ●