10
. Install the valve link onto the valve body,
as shown, using a 1/4 x 1 inch long clevis
pin. Secure the clevis pin with a cotter
pin (bend the ends of the cotter pin to
make it secure).
11
. Install the valve handle onto the valve link
using a 1/4 x 3/4 inch long clevis pin.
Secure the clevis pin with a cotter pin
(bend the ends of the cotter pin to make
it secure).
12
. Attach the valve handle to the valve spool
using a 1/4 x 1 inch long clevis pin.
Secure the clevis pin with a cotter pin
(bend the ends of the cotter pin to make
it secure). Attach the knob to the valve
handle, if necessary.
13
. Attach the high-pressure hose from the
filter assembly to the fitting on the side of
the valve. Securely tighten the hose fit-
ting.
NOTE:
The high-pressure hose is self-seal-
ing and does not require any type of sealing
material. Tighten the fitting with a 10 inch
crescent wrench.
6
. Bolt the rail rest to the rail assembly using
two 1/2-13 x 1-1/2 inch long hex head
bolts, lockwashers, and nuts, as shown.
Hand tighten the nuts.
Pull the latch mechanism outward and
rotate the handle to hold the lock pin in the
unlocked position.
7
. Block the wheels to prevent the base unit
from moving. Carefully lower the rail
assembly to a horizontal position. Secure-
ly tighten the nuts holding the base unit to
the rail assembly (Step 5) and the nuts
holding the rail rest assembly (Step 6).
8
. Link the ends of safety chains together
with the safety quick-link and tighten the
link’s locknut securely with a wrench.
9
. Place the hitch over the attachment tube,
aligning the bolt holes, and insert the rear
1/2-13 x 3 inch bolt (A). Install and tighten
the locknut.
Insert the end of quick link into front tube
of the rail assembly and insert a 1/2-13 x 3
inch bolt (B) through link and hitch. Install
and tighten the locknut.
Iron & Oak
14
815-672-8596
815-672-8596
15
Iron & Oak
Assembly Instructions
Assembly Instructions
