Handheld Vacuum H1 Owner’s Guide
2
EN
Charging
• Insert the charger into the charging port of your handheld vacuum.
The LED light will flash blue when charging. Once fully charged, the
LED light will turn off.
• The LED light will flash red when your handheld vacuum is low
on battery.
• It is recommended to charge your vacuum after each use to
maintain maximum performance.
Your handheld vacuum can be wall-mounted using the wall mount
bracket, drywall anchors, and screws provided.
When selecting a location, ensure there are no utility/service lines
(electrical wiring, water supply, gas supply, air, etc.) located directly
behind the mounting location. Mount the bracket in accordance with
all applicable codes and requirements. The use of personal protective
equipment, such as safety glasses and gloves, is recommended.
Storage
Using Your Handheld Vacuum
Using the wall mount bracket as a template, mark the location of
the screw holes.
Using a 5/16 inch (8mm) drill bit, drill two pilot holes and insert the
drywall anchors into the pilot holes.
Install the screws and bracket until
the wall mount is held firmly in
place. Do not over tighten.
1
2
3
Note:
The vacuum requires up to 4 hours to be fully charged.
Note:
As a safety precaution, the vacuum cannot be switched on
while charging.
Caution:
Do not mount the bracket at a height greater than 3 feet (1 meter)
from the floor.
Note:
If mounting directly onto a wall stud, it is not necessary to install the
drywall anchors. Use the screws to secure the bracket onto the wall stud.
Note:
For household indoor use only.
