IRMA6-SENSOR-HD-00-SWITCH-(IO)-00-(R)(1)
Installation Manual | Released
Rev. 1.4 | 12/2020
6
/ 27
Needed Tools
Drilling machine
with twist drill (10 mm)
Jig saw
Hex Key
size 4 mm
Most relevant steps at a glance
Essential directives for installation
1.
Prepare needed tools and drilling templates, IRMA 6 sensors as well as
cables for doors to be equipped.
2.
Install IRMA 6 into vehicle doors panels and connect IRMA 6 via Ethernet
to data transmission, to power supply and (optionally) to door contacts.
3.
Configure IRMA 6 via web interface, while using RJ 45 service cable and
ETH interface.
4.
Perform a commissioning test on your pc or on-board computer.
•
In all considerations with regard to installation positions and orientation, it is
assumed that the observer is inside the vehicle.
•
The sensor-to-door distance
must not exceed 20 cm
if the installation height is less
than 2 m, see Table 1, p. 4.
•
Install IRMA 6 on a horizontal surface. The maximum permissible deviation from the
horizontal plane is ±5°.
•
IRMA 6 must be installed by staff that follows the pertinent regulations and the
installation manual.
2
Mounting
