Dip Switch Settings (continued...)
For example, to set the camera’s baud rate to 9600bps, Pelco-P protocol and standard image (not flipped), refer to the
settings shown for Switch Bank 2 in the table below.
Reboot Camera After Changing Any Dip-Switch Settings.
Connections
The camera is fitted with a 2 meter connection cable which supplies power and data and delivers the composite video
signal. This cable is fitted with a 6 pin screw locking connector. The pin outs are detailed below.
Observe Extreme Care When Connecting Camera. Avoid Incorrect Polarity Which
Could Cause Irreparable Damage To Camera.
TIP! If there is no movement from the camera try swapping over the RS485 data wires.
The camera is also shipped with an extension cable pre-made with standardized power and video connectors (Item.6 -
Umbilical Cable). The two data wires are coloured red (RS485 A+) and black (RS485 B-).
Do Not Confuse the Red and Black Data Wires on the Umbilical For 12VDC Supply!
Iris Innovations
IM-PTZ-16-INST-DOCv1.1
7
SW2
SW2
SW2
SW2
SW2
SW2
SW2
SW2
SW2
SW Pos
1
2
3
4
5
6
7
8
ON
OFF
OFF
OFF
ON
ON
OFF
OFF
Pin No.
Function
1
Video Signal
2
Ground (POWER)
3
+12VDC (POWER)
4
RS485 Data B-
5
RS485 Data A+
6
Video Ground
IM-PTZ-UCAB - Umbilical Cable (Item.6)
BNC Connector - Video
2.1mm DC Connector - Power
RS485 Cores - Data