Iridium GO! Vehicular Kit
6
WARNING
Do not drive distracted. Discontinue or decline to take a call if you cannot concentrate on
driving. Use only in hands-free mode. Failure to do so may cause serious injury or death.
Do not use the antenna on vehicles at speeds greater than 145kmph / 90mph under normal
driving conditions, and do not use the antenna under extreme driving conditions or subject
to extreme vibration. Use at greater speeds or in extreme conditions could dislodge the
antenna from the vehicle allowing it to strike persons or property, resulting in serious injury
or death, or in damage to the vehicle or other property.
Before mounting antenna on vehicle, clean all oil, dirt, snow, and ice from the surface of the
vehicle and the bottom of the magnet, and dry all moisture from both surfaces. Failure to do
so could prevent a proper magnetic bond, allowing it to become detached and strike persons
or property, resulting in serious injury or death, or in damage to the vehicle or other property.
Carefully place the magnet mount onto a flat steel, factory-painted surface avoiding any
bumps, grooves or damaged surfaces. Failure to do so could prevent a proper magnetic
bond, allowing it to become detached and strike persons or property, resulting in serious
injury or death, or in damage to the vehicle or other property.
Use a secondary retention system to prevent unintentional detachment or loss of the
antenna. The properly tightened feeder cable could be used for this purpose. Failure to
secure the antenna could allow the antenna to dislodge from the vehicle allowing it to strike
persons or property, resulting in serious injury or death, or in damage to the vehicle or other
property.
Without bending the cable, minimize the amount of cable between the vehicle and the
antenna to reduce wind drag. Do not exceed 500mm of exposed cable. Too much cable
could cause the wind to bounce the cable against the vehicle or could allow the antenna to
dislodge from the vehicle, allowing it to strike persons or property, resulting in serious injury
or death, or in damage to the vehicle or other property.
The Iridium GO! device utilizes a negative ground system. When using a DC power source,
such as a car or boat, the power system must be a negative ground system. Do not use the
device with positive ground systems. Failure to properly ground the Iridium GO! device could
cause fire or could cause the device to fail so that it is unavailable in an emergency situation,
preventing or delaying an emergency response. These hazards could cause serious injury
or death.
Use the Iridium GO! device with Iridium supplied power accessories ONLY. Use of non-
Iridium supplied power accessories could result in exposing the device to excessive voltage,
which could cause fire or could cause the device to fail so that it is unavailable in an
