HDC-5016-HDC-5064 IP to QAM Modulator User Manual
Date 8. Dezember 2022 *) depend on model types
BLANKOM-HDC-5016-32_IP2QAM-modulator-V1.6-RR-12-2022.docx
44
Installation pre-conditions
⚫
Installing the device at the place in which environment temperature between 0 to 45 °C
⚫
Making sure good ventilation for the heat-sink on the rear panel and other heat-sink bores if
necessary
⚫
Checking the input AC voltage within the power supply working range and the connection is
correct before switching on device
⚫
Checking the RF output level varies within tolerant range if it is necessary
⚫
Checking all signal cables have been properly connected
⚫
Frequently switching on/off device is prohibited; the interval between every switching on/off
must greater than 10 seconds.
Conditions where you need to unplug the power cord
⚫
Power cord or socket damaged
⚫
Any liquid flowed into device
⚫
Any stuff causes circuit short
⚫
Device in damp environment
⚫
Device was suffered from physical damage
⚫
Long-time idle
⚫
After switching on and restoring to factory setting, device still cannot work properly.
⚫
Maintenance needed
Packing list
⚫
HDC-5016…64 IP QAM Mo
dulator
1 pc
⚫
User’s Manual
1 pc
⚫
Power Cord, dep. on country
1 pc
Appendix Important Notes!
This manual is for use by qualified personnel only. Handling this device or system requires special electronic technical
knowledge. To reduce the risk of electrical shock or damage to the equipment, do not perform any servicing other than
the installation and operating instructions contained in this manual unless you are qualified to do so. This device operates
in the given voltage and frequency range without requiring manual adjustment.
Do not open the top case w/o unplugged power source because serious injury or death may be the result! Inside are
components under risk from electrostatic discharge. To avoid equipment damages do not touch these components or,
observe the respective handling rules!
For continued protection against fire, the fuses may only be replaced by identical fuses with the same electrical
specifications which are designed for the corresponding fuse positions.
No part of this publication may be reproduced in any form or by any means or used to make any derivative work (such as
translation, transformation or adaptation) without the written permission from Blankom / IRENIS GmbH.
IRENIS GmbH reserves the right to revise this publication and make changes in its content from time to time, whereby it
shall not be obligatory for IRENIS GmbH to provide notification of such revision or change.
IRENIS GmbH provides this manual without warranty of any kind, neither implied nor expressed, this includes also any
warranties regarding the merchantability and fitness for a particular purpose. IRENIS GmbH may improve this manual or
make changes in the products described herein at any point of time.