iRecord PMR-200, Руководство пользователя

Страница: 33 / 40

I am recording a movie (audio/video stream) but I always end up with an MP3
audio file?
Check that S-video or RCA video cable is properly plugged in. Also make sure that
video source is ON and contents playing.
The recorded file appears as iRecord_xx/xx/xx xx:xx in the iPod. How can I
rename/delete it?
Attach your iPod to PC/Mac and browse iPod contents in iTunes (under DEVICES).
1. To delete a file, simply select it and press "Delete" key.
2. To rename a file right-click on it and select "Get Info". A dialog box will
appear. Select "Info" tab and rename the file.
How should I connect mono audio source to iRecord Pro?
Mono audio source has only one audio output connector. But iRecord Pro has two
audio input connectors( Left and Right channel) to support stereo audio sources.
Mono audio source must be connected to Right audio input connector on iRecord
Pro to get better audio quality.
I accidently switched off the device during firmware upgrade, and now
iRecord Pro will not start. The status LED does not lit up.
The iRecord Pro firmware has been corrupted due to power loss during
upgrading. However, the situation can be recovered from, by using the restore
mode of iRecord Pro. Power off iRecord Pro, attach it to your PC/Mac, and then
press & hold the record button while powering on. iRecord status LED will turn
green. Now use 'iRecord Restore' utility to restore iRecord Pro firmware to factory
settings. iRecord restore utility gets installed when you install iRecord Desktop
Software on your PC/Mac.
Page 32