9
Frame Timeout
3.2
In the frame + line mode, when the number of line signals has not reached the defined line height,
the image will be displayed only after the subsequent line signals reach the defined line height.
In special circumstances, if the line signal does not reach the defined line height, the camera will wait
for the subsequent line signal. At this time, the frame signal will be filtered out and frame loss will
occur. After turning on frame timeout, set the duration of one frame. If there are no enough line
signals within this time, the camera will blacken the remaining lines and output a frame of image.
Select
AcquisitionControl
, and then configure time of
FrameTimeout
.
Frame timeout
Figure 3-5
This function needs to enable frame + line trigger at the same time.
Acquisition Mode
3.3
Three acquisition modes are available: Continuous acquisition, single frame acquisition, and
multi-frame acquisition.
Click
Acquisition Mode
to select the corresponding mode.
Step 1
Select
MultiFrame
, that is, multi-frame acquisition.
Multi-frame acquisition
Figure 3-6
Select
AcquisitionFrameCount
, and then configure the parameters.
Step 2
Number of acquisition frame
Figure 3-7
