13
14 Camera / Lens Adjustment / Remote Back Focus
1. Using the supplied 3mm Allen wrench, loosen any two adjacent screws of
the four available ball pivot screws (Figure 16). This should loosen the ball
enough to allow repositioning of the camera to the desired orientation.
Tighten the screws to secure the camera module in place.
2. You can rotate the upper arm section by loosening the secured fitting, shown
in Figure 17, by turning it counter-clockwise.
Once the lower arm is rotated to the necessary position, retighten the fitting
by turning it clockwise.
3. Remove the lens cap with the supplied Allen wrench to expose the lens
(Figure 18).
Figure 16
Figure 18
Figure 17
