Fitting the backplate
Once the backplate has
been removed from the
p a c k a g i n g p l e a s e
ensure the timeswitch is
re-sealed to prevent
damage from dust and
debris.
The backplate should
be fitted with the wiring
terminals located at the top and in a position that allows a total
clearance at last 50mm around the unit.
Direct wall mounting
Offer the backplate to the wall in the position where the
timeswitch is to be mounted, remembering that the backplate fits
to the left hand end of the control. Mark the fixing positions
through the slots on the backplate (fixing centres of 60.3mm), drill
and plug the wall, then secure the backplate in position. The slots
in the backplate will compensate for any misalignments of the
fixings.
Wiring box mounting
The backplate may be fitted directly onto a single gang steel flush
wiring box complying with BS4662, using two M3.5 screws. The
CP017 is suitable for mounting on a flat surface only; they must
not be positioned on a surface mounted wall box or on unearthed
metal surfaces.
N
L
1
2
3
4
100mm
50mm
50mm
50mm
2
