Chapter 3 Power on/off the Device
3.1 Enable the device
· Boot up with IC card
Put the IC card on the card response area and after the beep sound, the device will boot up, together with the PC and projector if it’s set with
correct starting control code. At the same time, central control, amplifier and wireless MIC will be power on. To use the document camera, users
just need to press switch to open the door and lift up the arm.
·
Boot up with the digital code
Press ‘OK’ key and stop when blue and red lights show up, then input the digital code to boot up the device. Please kindly note that the digital code
mode will exit if user fails to input the number within ten seconds. For more detail, please check “Chapter4: Digital Password and Card Setting”.
·
Other methods
User could press the keys at front panel to start the projector, switch signal source, restart the PC, adjust the volume and etc.
1. Card response area: Boot up the device with the card.
2. Power: Power on/off the device.
3. Computer: Power on/off the PC.
4. Lock: Freeze the functions on the panel.
5. Projector : Boot up/shut down the projector.
6. Source input: Switch signal sources between PC, front VGA and HDMI.
7. Touch off: Disable the touch function and screen off.
8. Eco mode: Start the power-saving mode of projector.
9. Volume adjustment: Turn up/down the volume or mute.
10. Number keys: Input or reset digital code.
11. IQ USB port: Enable touch function when connected to external device.
12. USB ports: USB IN*4
13. Audio port: Audio IN*1
14. VGA port: VGA IN*1
15. HDMI port: HDMI IN*1
Chapter 2 Central Control Panel
3.2 Disable the device
· Put down the arm of document camera and close the door manually.
· Press “Power” button to shut down the device. Please kindly note that it will be postponed for 3 minutes after shutting down the device to
entirely power it off, which is to make heat dissipation of the projector.
1
2
4
5
7
6
8
15
9
10
11
3
12
13
14
03
