17
the control code.If your projector cannot be found in the list model, please set the baud rate, parity
check code, command code and other contents of the current serial port according to the technical
parameter requirements of the projector manual, and select and input in the command box.
3) After setting the control code, click the send button, after long pressing the buzzer of the IQAio, the
control code of the projector has been written into the memory chip of the central control, and then the
switching function of the projector can be realized.
Chapter Ten - Whiteboard Software
Whiteboard
Software
Technical
Principal
Infrared technology
Touch
point
Support 10-point touch control and synchronous writing, no need for
special pen, use finger or other non-transparent materials to operate
directly on the whiteboard, to avoid later use loss;
Response
rate
8m/s
Position
accuracy
0.05mm
port
USB2.0 and above
Shortcut
key
15 silk-print shortcut keys on the left and right side
Material
Anti-glare, no light spot, high contrast, good color reduction, low
reflection, strong and wear-resistant, anti-scratch, dustproof, smooth
writing and support pen writing;The normal use of the board will not
be affected even if the board is damaged, perforated or dented due to
accidents.It uses double-sided metal plate material to shield other
signal interference more better.
Chapter Eleven - Attention
1. Do not clean the whiteboard with wet cloth to prevent water from entering into the touch module
and causing product malfunction;
2. Do not dismantle the machine by yourself;
3. Please stay away from heat sources, water sources and corrosive substances;
4. During routine maintenance of the whiteboard, please power off the equipment and use dry towels
to clean the black plastic sheet on the lower frame;
5. The normal range of working temperature: 0℃
～
+40℃;
6. When not in use for a long time, the device should be closed and unplugged.
