12
2. Introduction of equipment use
1) First, complete the connection of wires required by the equipment (such as the schematic diagram of
equipment connection).
2) Power on method
①
,
power on by swiping the key ring: use the key ring configured by the product,
Hearing the sound of "di" means the equipment including the computer and the projector (the
equipment must correctly write the power-on control code) have been powered on synchronously, at
the same time, the central control, power amplifier, wireless microphone (receiving end) and other
equipment has been connected to the power supply.
3) Power on method
②，
One key power on: long press "power on/off" button for 3 seconds to power
on the device. The power-on function of "power on/off" button can be turned off by the intelligent
central control tool of the computer. After turning off, the device can only be powered on by swiping
the card, while the device can be powered off by long press the "power on/off" button.
4) Users can also independently perform "power on/off", "computer", "projection", "signal source",
"/-", "mute" and other operations;
Chapter Six - Instructions for RFID Card
1) RFID Card to power on, the premise is that the machine has been equipped with card password, and
the factory standard card has been configured with a password;
2) Stick the matched card in the center of the "card" area, and remove the card after hearing the sound
of "di", and the Aio machine will be powered on;
3) If the card is wrong, the buzzer will continuously alarm;
4) when power off the machine, stick the matched card in the center of the "card" area, and remove the
card after hearing three "di" sounds. The IQAio will be powered off.
