PDFMAILER.COM Print and send PDF files as Emails with any application, ad-sponsored and free of charge www.pdfmailer.com
I P W i r e l e s s B r o a d b a n d M o d e m U s e r G u i d e
1 3
The LEDs show data transmit (Tx) and receive (Rx) activity. The LEDs will flicker
when data is transferring.
x
Power Button
Press the power button for one second to turn the modem on.
The red LED of the
will illuminate when the unit is ON.
y
Signal Strength (4 Yellow LEDs)
The 4 yellow LEDs on the left of the disply indicate the radio signal strength. When only
the bottom yellow LED is illuminated, you have minimum signal strength required to
transmit and receive data. Each subsequent LED indicates increasing signal strength.
When all 4 LEDs are illuminated, you can transfer data at the maximim speed of the
IPWireless Broadband Modem, or at the service level you have selected.
z
DC Power Jack
The pin end of the power cable plugs into the DC power jack located on the side of the
IPWireless Broadband Modem.
{
Built-in Stand
The built-in stand on the back of the unit supports the IPWireless Broadband
Modem.
|
PC Interface Cable Connection
The 20-pin connector on the USB or Ethernet cable plugs into the PC port on the side of
the modem.
}
Antenna
Raise the antenna to its vertical position to connect the PC Interface Cable. When the
antenna is vertical, it receives signals equally in all directions. Place the antenna in the
vertical position (as shown in Figure 1) when the IPWireless Broadband Modem is in
use, and in the down position (adjacent to the body of the IPWireless Broadband
Modem) when not in use. Do not force the antenna beyond its vertical position.
