iPECS eMG800
Hardware Description and Installation Manual
Issue 1.8
74
5.1.2.2
SLT wiring
SLTs are wired to the center pair of the RJ11, typically on the bottom or back of the SLT. The wall outlet should
be connected back to an appropriate SLIB or DSIU SLT port.
Refer to the pin-out chart below and Figure 5.1.1-1,
1)
Wire the center pair of the wall outlet to the SLIB or DSIU termination point using UTP cable.
2)
Using the line cord provided with the SLT, connect the SLT to the wall outlet.
Table 5.1.2.2-1 Standard SLT Pin-out Chart
Line Cord
CONNECTOR
PIN
SIGNAL NAME
RJ11
1,2
Not used
3
Ring
4
Tip
5,6
Not used
5.1.2.3
LIP Phone Keyset Wiring
iPECS eMG800 supports LIP Phone series. LIP-7008D and LIP-8004D have a single LAN port that is wired to
an Ethernet switch port. Generally all other LIP phone series shown here have two (2) Ethernet ports, a LAN
port and a PC port. The LAN port is connected to an Ethernet switch port and the PC port is connected to the
LAN port of a PC. The LIP phones are wired to any 10/100 (or 1000) Base-T Ethernet switch port with access
to a VOIB channel. The LIP phones can be powered from a POE compatible Ethernet switch port or using the
AC/DC Adaptor-K.
Figure 5.1.2.3-1 LIP Phone Connection
Table 5.1.2.3-1 LIP Phone Pin-out Chart
CONNECTOR
PIN
SIGNAL NAME
FUNCTION
RJ45
4,5,7,8
Not used
1
TX+
Transmit Data
2
TX-
Transmit Data
3
RX-
Receive Data
6
RX+
Receive Data
1)
Using the above wiring chart, wire the RX and TX pins from the RJ45 Wall outlet, or equal, for the
IP Phone to the appropriate Ethernet switch termination point using Cat 5 or, for 1000 Base-T Cat
5e UTP cable. The maximum wire length between the IP Phone and the Ethernet switch port is 100
meters or 328 feet.
2)
Use the RJ45 terminated cable provided with the phone to connect the IP Phone LAN port to the
Wall outlet.
3)
Connect the PC port to a PC LAN port using a CAT 5 cable terminated on each end with an RJ45
connector.
