INTRODUCTION/GENERAL
WARNINGS/SAFETY
________________________________________________________________________________
p. 10 of 14
DESCRIPTION OF AUTOMATIC PROGRAMS P1- P2- P3
Note: the contents of this chapter can be applied to all the models described in this manual.
P1 Light intensity cleaning program for smooth not excessively dirty floors.
P2 Medium intensity cleaning program for smooth floors with evident forms of dirt.
P3 Very intense work program for very dirty rough floors (concrete and similar).
USE
After selecting one of the three programs described above, select forward operation via the lever on
the control panel (2) and press the accelerator pedal to start work.
Note: by releasing the accelerator or setting the lever to neutral, all the functions will automatically
switch off within approx. 5 seconds (Auto Power-Off); in this pause condition the light indicator
corresponding to the pre-selected program will blink. To re-activate the functions, simply move the
machine forward, without disabling the program already selected (Auto power-ON).
A safety device is housed in the seat: when the operator stands up or abandons the machine, the
drive stops in both forward and reverse direction.
Note: if reverse gear is engaged during work, the vehicle will automatically raise the squeegee and
only once this has been done will the consent be given for operation. Use of reverse gear is
identified by a safety buzzer (all the functions will remain active).
The machine automatically brakes when the acceleration pedal is released; if necessary the service
brake can be used.
The machine is provided with an emergency stop button; when the button is pressed (red light on),
the drive and all the other functions will immediately stop.
To re-activate the machine, press the button again. To resume work, one of the three automatic
work programs must be re-selected.
Once you have finished work, the dirty liquid must be emptied from the tank.
Inside the dirty water recovery tank there is a floater microswitch which, once it has detected that
the tank is full, automatically de-activates the suction motor. This condition is modified by switch-
on of the pilot light on the dashboard.
CLEANING SOLUTION DELIVERY STOP
When the cleaning solution tank is low an intermittent acoustic signal will be emitted (3 times) and
“water low” will appear on the display. After approximately one minute, the intermittent acoustic
signal will resume and “no water” will appear on the display; at the same time the brush motors and
water delivery will stop.
Fill the tank to continue work after switching the machine off to re-set the alarm signals.
https://harrissupplyind.com - To Order Parts Call 608-268-8080
