IOtech Personal Daq/3000, Руководство по установке

Страница: 10 / 12

IG-10
957593
Personal Daq/3000 Series Installation Guide
Personal Daq/3000 Series
Reading Thermocouples
Personal Daq/30 d rily for high-speed acquisition of voltage inputs. However;
they can also be used to obtai he application
software in use. After taki g t e
DaqView Users
1)
Start DaqView.
2)
Open the Hardware Configu ttings).
3) Select Differential mode h orner of the window.
Now you will be able to select a thermocouple type in the input channel Type column.
4)
Go to the Acquisition Setup tab and click on the <Preferences> button. Then, select an oversampling
number of at least 128. This is done in the lower left hand corner of the Preferences window. (Note 1)
ging setting that is appropriate for your situation (depends on your AC line
want voltage inputs to be included in the line cycle averaging).
DASYLa
1)
Start DAS
2)
Open the tup).
3)
Highlight th hardware tree] and click on the <Properties> button.
4)
Select Differential Inputs as the Signal Input
5) In the Hard r hlight the pDaq/3000 device.
Click on the
7) Click on t
8)
Using the st 128. (Note 1)
9) Select the L line
frequency a
10)
Click the <A
11)
Click <OK> to exit out of the Hardware Configuration window.
12)
Create an A/D module in the DASYLab worksheet (type: pDaq3000 Direct AI).
13)
Double-click on the module to open its Prop
14)
Click on the <Channel Setup> button.
15)
Select the applicable thermocouple type and temperature units.
16)
Click the <Apply> and <OK> buttons.
Note 1
: The maximum sampling rate is reduced by a factor dependent upon the oversampling selected.
Notes:
00 Series evices are designed prima
n temperature readings. The steps that you should take depend on t
n hes steps you will obtain good temperature readings from your device.
ration window (Device> Configure Hardware Se
. T e selection is made from the lower right hand c
5)
Select the Line Cycle Avera
frequency and whether you
b Users
YLab.
Hardware Configuration window (Experiment> Hardware Se
e Analog Inputs entry [in the
Mode; then click the <Apply> and <OK> buttons.
wa e Configuration window, hig
6)
<Properties> button.
he “Clock Settings” tab.
pull-down menu, set the Oversampling number to at lea
ine Cycle Averaging setting appropriate for your situation. This depends on your AC
n in the line cycle averaging. d whether you want voltage inputs to be included
pply> and <OK> buttons.
erties window.