IG
-4 DaqBoard/2000c Series Installation Guide
10-17-02
1061-0940, rev 3.0
12.
Plug in all cords and cables that were removed in step 3.
13.
Apply power to, and start up the PC.
Note
: At this point some PCs may prompt you to insert an
installation disk. While this is rare, if you do receive
such a prompt simply place the install CD into the disk
drive and follow the screen prompts.
Step 3
–
Configure Boards
DaqBoard/2000c Series boards have no jumpers or switches to set. Configuration is performed entirely through software.
Refer to the following figure and steps to complete the configuration. The numbers in the figure correspond to the numbered
steps immediately following the figure.
Accessing the DaqBoard/2000 Properties Tab
Securing a DaqBoard/2000c Series Board
