The Victron Smart Solar MPPT charge controller uses maximum power point tracking that optimizes the match between the solar array
and the battery bank. It converts the higher voltage DC output from the solar panels down to the lower voltage needed to charge the
batteries. The PV solar array is connected to the MPPT charger with a circuit breaker (not supplied). The specified circuit breaker is rated
at 48VDC. If the PV solar array has an open circuit voltage that is higher, then another circuit breaker with a higher voltage rating must
be substituted.
The charger is connected to the MRBF fuse block via a switch and a 40A fuse. The fuse and wire sizes are based on the Victron MPPT
100/30 charge controller. If a larger controller is used then the fuse and wire sizes should be increased as required.
Remotely control and monitor the Victron Smart Solar MPPT charger with built-in Bluetooth by pairing it with your smartphone via the
VictronConnect App.
Solar Diagram
LITHIONICS BATTERY, CLEARWATER, FL 33765 USA | PH: 727.726.4204 | FAX: 727.797.8046 | WEB: LITHIONICSBATTERY.com
12
