Connecting the Video Source (camera)
The ioibox unit accepts video input from analog cameras and devices.
To Connect a Video Source to the ioibox unit
1. Securely connect the video cable to the output of the camera or device.
2. Connect the other cable end to ioibox unit VIDEO IN connection on the back of the
ioibox unit.
Tip
For ioibox units, be certain to note which camera is connected to each channel of a Block
(pair of channels that has an individual IP). This information will help during configuration in
the ioimage Setup.
Note
For PTZ cameras, you will need to connect the control lines of the PTZ camera in order to
use the pan, tilt, and zoom operability. For more information, see the
Camera Control Lines (Remote Control)
procedure (page 40).
Connecting Relay Outputs
For incident responses and device automatic commanding through the ioibox, you can connect
external devices, such as door locks, lights, etc. to the Normally Open or Normally Closed relay
outputs of the unit.
Relay outputs connected to the ioiboxes can be assigned as automatic incident responses to
events and alerts received on the ioiboxes. These are events such as intruder alarms, poor signal,
low visibility, etc. For example, an intruder is detected in a courtyard, as an automatic incident
response, exit doors are locked and security shutters are closed.
For more information on incident responses and relay outputs, refer to the ioimage HTML Edition
Setup User Guide.
Caution
To prevent damage to the ioibox units, do not exceed the voltage and current ratings for
Relay terminals.
CAUTION
To avoid damage to the system and system interference, a certified electrician must assure
that the ground voltage (ground loops) is comparable among all connected system
components.
34
