STORAGE:
It is important to keep fluid in the unit when storing for an extended period of
time, it will keep the seal and the parts lubricated.
1. Remove the tank cap at the back of the fogger (power cord side).
2. Pour liquid into the tank.
3. Store on a flat, level surface to prevent liquid from spilling.
FUSE REPLACEMENT
If the unit does not function at all when connected to the main power supply then it is highly likely that the
fuse has blown.
WARNING
: Risk of electric shock and fire. Disconnect from main power supply before attempting to
replace fuse.
1. Using a Phillips head screwdriver, remove fuse cover on back of unit by turning counter clockwise
to reveal the fuse.
2. Replace the fuse with the same size and type fuse: 5A, 125V
Place fuse in cover and reinstall by turning clockwise. Be sure not to over tighten.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could
void user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and
receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.-- Consult the dealer or an experienced radio/TV technician for help.
Congratulations on the purchase of your new fog machine!
FOR INDOOR USE ONLY
SAVE THESE INSTRUCTIONS
© Seasonal Visions International
1368 Park Ave. Emeryville,
California 94608 Tel: 510-428-3921
All Rights Reserved
MADE IN CHINA
Update:2014-2-27
