involight A-000000-05892, Руководство пользователя

Страница: 23 / 56

22
1.3 Intended use:
This device is an effect emitter with which decorative light effects can be generated. The INVOLIGHT "PAINTBAR
HEX12PP" can be operated in AUTO mode or music mode. The product is intended for professional applications,
e.g. on stages, in discos, theaters, etc. and is not suitable for room lighting in households. This product is only
approved for connection to 100-240 VAC, 50 / 60Hz alternating voltage and has been designed for indoor use
only. The device must not be used or stored in an environment in which splash water, rain, moisture or mist can be
expected. Moisture or very high humidity can reduce the insulation and lead to fatal electric shocks. When using
fog machines, please ensure that the unit is never directly exposed to the fog and is operated at least 0.5 m away
from a fogger. Do not use the unit during a thunderstorm. Overvoltage could destroy the device. Disconnect the
appliance from the mains at all poles. Make sure there are no cables around. You endanger your own and the
safety of third parties! The ambient temperature must be between -5 ° C and + 45 ° C. Keep the unit away from
direct sunlight and radiators. Do not operate the unit until after you have familiarized yourself with its functions. Do
not allow the appliance to be used by persons who are not familiar with the appliance. Please note that
unauthorized modifications to the device are prohibited for safety reasons. If the device is used in a different way
than described in this manual, this can lead to damage to the product and to the warranty claim. In addition, any
other use is associated with hazards such as short circuit, fire, electric shock, crashes, etc.
Part 2: Installation:
Unpack the unit and carefully check it for damage before using it. Place the unit in a suitable location or hang it on
a suitable crossmember. The device must be secured with an approved safety cable when the mounting is
suspended. In addition, the mounting bracket must be screwed and tightened with the enclosed screws! Then
connect the device to the power supply.
The appliance must not be operated directly after it has been brought from a cold to a warm room. The resulting
condensation may destroy your unit. Leave the unit switched off until it has reached room temperature!
During installation, the provisions of BGV C1 (formerly VBG 70) and DIN 15560 have to be observed! The
installation may only be carried out by authorized specialists!
IMPORTANT! Overhead mounting requires a high degree of experience. This includes knowledge of the load-
bearing capacity, the installation material used and the safety inspections of the material and the projector used,
but the required experience is not limited to this alone. Under no circumstances should you try to perform the
installation yourself if you do not have the appropriate qualification. Instead, commission a professional installer.
Incorrect installation may result in personal injury and / or damage to property.
Part 3: Functions and operation:
The device is connected to the power supply via the mains cable. You can adjust and influence the different
operating modes via the on-board menu.
3.1 Operation:
The INVOLIGHT "PaintBAR HEX12PP" is a DMX 512 controllable LED effect light. It can be controlled via 5, 6 or
41 DMX channels, automatically or music and used as master or slave. The device is connected to the power
supply via the mains cable. A powercon extension (optional) allows the current to be routed from one to the next
device. This allows multiple devices to be powered from a wall outlet. You can set and influence the different
operating modes and via the on-board menu. The "PaintBAR HEX12PP" can be controlled with any commercially
available DMX controller.
Picture 1 (backside):
2. 3.
4. 5.
6. 7.
8.
1.