INVISIBLE FENCE Invisible Gate Plus, Руководство пользователя

Страница: 8 / 16

www.InvisibleFence.com
8

Verify Signal Field Range
o
Holding the Computer Collar
®
unit, start outside the range and move slowly
towards the Invisible Gate
®
Plus transmitter. Do not touch the correction posts at
this time.
o
The Computer Collar
®
unit will beep as it approaches the outer range of the
signal field width set in Step 2. The beeping will be accompanied by a correction.
o
If the Computer Collar
®
unit fails to beep, see the troubleshooting chart on page
11.
o Adjust range and/or relocate the Invisible Gate
®
Plus transmitter until desired
area is protected.

Changing the Channel Setting on the Invisible Gate
®
Plus transmitter
o
Remove the control panel cover.
o
Press and release the RANGE DOWN (-)
button until 0 appears on the LCD.
o
Locate the switch for the Channel (A),
Channel (B) and (A+B) Channel.
o
Select the desired channel setting.
Note: The Invisible Gate
®
Plus transmitter
will not enter into programming mode if
the switch is set to A+B. See Programming
Computer Collar
®
unit on Page 9
o
Adjust and verify signal field range.
o
Replace the control panel cover and hand
tighten the four screws.
Note : Ensure the O-ring is seated in the
channel before replacing the control panel
cover. Failure to do so may allow moisture
leakage and possible failure of the device.
Boundary Plus
®
Operation:
In Boundary Plus
® mode your pet’s Computer Collar ®
unit will activate as your pet crosses over the
Invisible Gate
®
Plus transmitter. This patented technology allows you to position the transmitter in
a doorway to prevent entry into a room without impeding your
pet’s movement near the
transmitter. Ensure the BOUNDARY PLUS/SHIELDS switch is in the Boundary Plus
®
position
.

Adjust Signal Field Range
o
Determine the desired location and the signal field range required.

Wireless: 10 inch minimum up to 34 inch maximum signal field height.
 Signal field should be set to activate your pet’s Computer Collar ®
unit 10 to 16 inches
above where sits on your pet neck.
o
With the unit ON, press the RANGE UP (+) or the RANGE DOWN (-) buttons to increase or
decrease the signal field range. The first indicator equals 10 inches of signal field. Each additional
number represents approximately 6 inches of range.
Control Panel