Inverto IDL 7000PVR, Руководство пользователя

Страница: 16 / 136

1EnIDL7000PVR-S.fh10 17/1/06 13:16 Page 15
Composite
C M Y CM MY CY CMY K
2.1.8.2 Advanced (Single) Channel Search
In addition to the automatic search, a manual search
procedure is also available. In this case you must search s
pecifically for new programmes on a specific satellite
transponder. Unlike the automatic search procedure, here
you must enter all reception parameters explicitly.
The technical reception parameters that must be entered in
this display can be obtained either from satellite magazines,
from the Internet, or from the relevant programme provider.
The following information must be input:
Satellite: First select the satellite position to be searched.
Below this you will see a display of the current signal strength.
Frequency: Here you must enter the five-digit transponder frequency, e.g. 11836 for 11.836 GHz.
Polarity: Here you must enter the polarisation plane of the transponder (“Horizontal” or “Vertical”).
Symbol rate: Either select one of the two usual rates commonly found on the Astra and Eutelsat satellites,
22.000 as well as 27.500 symbols/s, or enter a specific value manually. The receiver is equipped to process
symbol rates between 2.000 and 45.000 symbols.
FEC-Code (Error protection): Here you must enter the type of error correction used by the programme
you are searching for. At a symbol rate of 22.000 symbols/s an FEC of 5/6 is standard, at 27.500 symbols/s
the FEC is usually 3/4.
If the manual programme search so far has not been able to find the programme you are looking for, it is
necessary to enter the following three
PIDs (Packet identifier) , which must be entered in four-digit form.
PID Video: Packet identifier for the video signal
PID Audio: Packet identifier for the audio signal
PID PCR: Program Clock Reference
Now press the red function key to initiate the manual programme search. All programmes broadcasting
within the framework of the specified parameters will be displayed, one after the other, on the following
page. You can then decide whether you want to store the newly found programmes in memory, or whether
you wish to discard them.
The search procedure can be terminated at any time by pressing the “Exit“ key. The response may
not be immediate.