ELECTRICAL CONNECTION
• Check that the voltage in your home corresponds with the voltage printed on the bottom of the appliance.
• The earthing of the appliance is compulsory by law.
•
Attention:
the connection point must always be accessible.
THE FITTING OF THE APPLIANCE
• Check that the cabinet and the cut-out meet the dimension and ventilation requirements.
• Remove the chips from the cutting job in the opening of the worktop and treat the saw ends of wooden or synthetic
worktops with sealing varnish if necessary, to prevent moisture causing the worktop to swell.
• Remove the protective layer from the sealing tape and apply the tape on the edge of the cut out on the worktop. . Do not
stick the tape around the corners, but cut 4 separate pieces to seal the corners well.
• Fit the supllied mounting brackets on the appliance.
• Lay the hob in the recess.
• Tighten the screws of the mounting brackets to firmly fit the hob in the cut-out.
• Connect the appliance to the electrical mains and the gas mains. The appliance is ready for use.
• Check that it works properly.
REMOVING THE HOB
Disconnect the hob from the electrical mains and the gas mains and loosen the screws of the mounting brackets. Remove
the hob by pushing it upwards from the bottom.
Attention!
Beware of damage to the appliance! Do not try to remove it
from the top.
GAS CONNECTION
• The connection of the hob to the gas pipe network must be made by means of a special gas hose or a
stainless steel hose with a continuous-surface complying with local regulations.
Always a stainless steel hose when placing the hob above an oven.
Attention:
the stainless steel hose must
hang freely. It must not be able to touch any moving parts of the cabinet.
• Check the perfect sealing after installation using a soapy solution.
English
•
23
