Switch off the appliance before you start to clean it. Remove the plug from the wall socket or switch the group switch in
the meter cabinet to zero.
Regularly clean the inside and outside of the cooker hood. Use warm soapy water with, for instance, washing-up liquid,
all-purpose cleaner or stainless steel cleaner. In order to clean the switches or the vicinity of the switches, only use a damp
cloth. Do not use aggressive abrasive cleaning agents or agents containing alcohol. In order to clean the switches or the
vicinity of the switches, only use a damp cloth.
Attention:
if the cooker hood is not cleaned in time, this could pose a fire hazard.
FAT FILTERS
A metal fat filter collects fat particles out of the air. As a result, depending on the use, the filter could block up after a period
of time. The metal fat filter does not have to be replaced, but should be cleaned at least once per month. This can be done
by hand or in the dishwasher at a low temperature. Make sure the fat filters are properly dry before they are placed back in
the cooker hood.
Do not use aggressive cleaning agents.
If the cooker hood is not cleaned in time, this could pose a fire hazard.
Cleaning the fat filters in the dishwasher could result in discolouration. It does not have an effect on the operation.
REMOVING THE FAT FILTER
Check that the plug has been removed from the
socket.
Pull the fat filter towards you and tilt it downwards to the
side.
Hold a hand under the filter when removing it, to make
sure that the filter does not fall on your hob when
removing it.
REPLACING CARBON FILTERS
A carbon filter cleans the air and filters the smells that are created
when cooking. Use a carbon filter if the cooker hood is not connected
to a discharge channel. A carbon filter cannot be cleaned. That is why it
should
be replaced every four months, depending on your cooking habits.
• Remove the fat filters
• Attach two carbon filters to the motor. One on both sides.
• Place back the fat filters.
operating the appliance
4
cleaning and maintenance
5
English
•
19
SWITCHING THE COOKER HOOD ON AND OFF
The cooker hood has three switches. The light switch to the left and two
switches
to the right for controlling the positions.
• In order to switch off the motor, both position switches should
be in the
0
position.
• Press the lower switch to
I
and the motor will run at the lowest position.
• Press the lower switch to
II
and the motor will run at the middle position.
• Press the lower switch to
III
and the motor will run at the highest position.
When the motor is off, you can directly switch on the motor at the highest position by pressing the top switch to
III
.
• Press switch
to switch on the lighting.
Press the same switch to switch off the lighting.
If necessary, switch on the lighting for sufficient light on your cooking section.
Preferably switch on the motor of the cooker hood at the required position a few minutes before you start cooking. Allow the
motor of the cooker hood to run for another 5 to 10 minutes when you have finished cooking, to remove all cooking smells
from the kitchen. When using a plasma filter, an extended run time of at least 15 minutes is recommended.