inventum AKO6001, Инструкция по эксплуатации

Страница: 21 / 28

MOUNTING AGAINST THE WALL
Attention: the cooker hood should be mounted onto a flat perpendicular kitchen wall.
Use the provided screws and plugs for mounting against the wall.
• Measure the right height for the cooker hood (min. 65/75 cm) and mark the underside of the cooker hood on the wall.
• Open the glass visor gently by pulling it towards you.
• Remove the grease filters to expose the interior of the cooker hood. A keyhole slot (A) and a retainer hole (B) will be visible on
either side of the back panel.
• Hold the cooker hood level against the wall on the correct height according to the marking and mark the holes (A+B) on the wall.
• Drill the holes with a masonry drill off Ø8mm at the top of each marked slot and push in a rawl plug in each hole.
• Partly insert two screws in the plugs, with a head diameter slightly smaller than the lower opening in the keyhole slot. Leave
about 5 mm of the screw sticking out.
• Lift the cooker hood and slide the keyhole slots over the two screws.
• Mark the two lower retainer holes and lift the cooker hood down.
• Drill the holes with a masonry drill of Ø8mm and insert the plugs.
• Mount the cooker hood and place the screws in the retainer holes. Tighten all four screws.
• Replace the grease filters.
• Place an exhaust-air pipe when you have chosen a duct as the extraction system.
• Plug in the appliance.
MOUNTING BELOW A KITCHEN CUPBOARD
Attention:
if the cooker hood it to be mounted underneath a cupboard, also take the minimum height (min. 65/75 cm) into
account. Use the provided bolts, nuts and washers for mounting underneath the cupboard.
Advice:
Use the provided drilling template to mark the necessary holes for the bolts and for the hole of the exhaust when
connecting the cooker hood to a duct.
• Open the glass visor by pulling it gently towards you.
• Remove the grease filters to expose the interior of the cooker hood.
• Hold the cooker hood underneath the cupboard and mark the four retainer holes (B) and mounting aid holes (A) at the bottom
of the cupboard.
• Tape the drilling template to the bottom of the cupboard aligned with the marked positions and draw the hole for the power
cord and the exhaust pipe (C).
ø 120
90
545
35
225
112,5
42
16
70
ø 120
543
260
92
150
A A
B B
C
ø 120
90
545
35
225
112,5
42
16
70
ø 120
543
260
92
150
A A
B B
C
B B
English •
21
AKO6001-AKO6002-instructions.indd 21 27-8-2014 11:16:44