INVENTOR V3MFI-24, Руководство пользователя, Страница: 14 / 48

13
1. Clean the indoor unit and air filter.
2. Dry the inner parts by keeping the fan running for half a day.
3. Turn off the unit and switch off the power switch, remove the batteries from the remote control.
4. Periodically check and clean the inner parts of the outdoor unit. Our local dealer will help you
handle this if you contact us.
If the air conditioner operate abnormally, turn off the unit and switch off the power supply, and
contact the local dealer or service centre.
Before restarting, please check if the air inlet and air outlet of the indoor and outdoor units are
blocked up. Clean it so.
Before long time idleness
After long time idleness
Aftersales
CAUTION:
Make sure nothing has been forgotten or fallen into the fan before installing the air inlet grille.
Restart the unit after the air inlet grid is correctly installed and the loop is fastened .
Cleaning the air outlet:
After using for a period, the air outlet and louvers will become dirty. It is recommended to dip a soft
cloth into warm water or a mild kitchen cleanser, ring it out, then wipe any soiling from the unit.
After, wipe with a dry cloth.
Cleaning the Air inlet grille and Air Filter:
If the air filter becomes clogged, the performance will decrease and electricity will be wasted.
The air filter should be checked and cleaned about once every 2 weeks to maintain optimal
performance of the air conditioner.
Air Filter
Right side
filter
Left side filter
Bottom filter
Knob(both sides)
The backview of the air inlet grid
Air inlet grid
(It is tied by a rope inside)
NOTE: The Anti-formol filter fixed on the Air filter does not need replacement, just wash it with
cold water and dry it in the shadow.
1. There are three pieces of air filter attached with the air inlet grid, located at both sides and bottom of
the grid(see figure above).
2. Hold both upper sides of the grid and pull it up, let it slant downwards until the rope become straight.
3. Take hold of the side knobs of the air filter and pull it upward.
4. The air inlet grid should be removed first before take out the bottom filter. Use the screwdriver to
loosen the screw fasten the rope, then remove the air inlet grid.
3. The air inlet grid can be wiped with water or a cloth dipped water. Wash it with water and dry it in
a cool place.
4. Use a vacuum cleaner to remove the dust or wash the air filter with water, and dry it in the shadow.
5. Installation process of the air filter and air inlet grid is the reverse of the removal process.
CARE AND MAINTENANCE