If you want to run Pano360 in automatic mode, connect the 1
st
digital input (
Fig.1-I
/
Fig. 6
)
with your RC receiver. You can optionally connect the 3
rd
digital input (
Fig.1-K
/
Fig.6
) for remote
preset selection. Make sure the yellow (or white) cables for each connector are on the right side
for each connector (
Fig. 6
).
Fig. 6
Automatic mode connection example
If you want to control Pano360 manually then you need to connect the 1
st
digital input
(
Fig.1-I
/
Fig.7
)
and the 2
nd
digital input (
Fig.1-J
/
Fig.7
).
Fig. 7
Manual mode connection example
At this point you may want to bind your RC receiver with the RC transmitter if you haven't
already done so. Do configure your RC transmitter to trigger the channels that correspond to
Pano360 inputs. Please refer to your transmitter manual for more information on how to setup the
channels for your RC transmitter.
1
St
2
nd
3
rd
Digital input
Make sure the signal cable (yellow or white)
is on the right side of each connector
Make sure the signal cable (yellow or white)
is on the right side of each connector
1
St
2
nd
3
rd
Digital input
