Invacare Top End Terminator Jr., Руководство по эксплуатации и техническому обслуживанию

Страница: 38 / 44

38
This Procedure includes the following:
Adjusting/Replacing Flip-Up Footboard
Adjusting/Replacing Rigid Tubular Footrest
Anti-Tipper Replacement/Adjustment
FOOTREST/ANTI-TIPPER PROCEDURE 8
F
O
O
T
R
E
S
T
A
N
T
I
T
I
P
P
E
R
ANGLE.
1. Flip the footboard up.
2. Torque the angle adjustment screws:
IN (COUNTERCLOCKWISE) - to angle the
footboard downward.
OUT (CLOCKWISE) - to angle the footboard upward.
NOTE: Ensure that both angle adjustment screws
have the same number of threads showing.
3. Flip the footboard down.
Replacing Flip-Up Footboard
1. Loosen the two (2) hex screws on each clamp
securing the footboard to the wheelchair.
2. Slide the EXISTING footboard mounting bars out
of the clamps.
3. Slide the NEW footboard mounting bars into the
clamps on the wheelchair frame.
4. Tighten the two (2) hex screws on the clamps to
secure the footboard mounting bars to the wheel-
chair frame.
Hex Screws
Clamp
Mounting
Holes
Locknut
Coved Washers
Hex Screw
Footboard
Footboard
Mounting
Bar
ADJUSTING DEPTH AND HEIGHT/REPLACING
Footboard
Angle Adjustment Screws
ADJUSTING ANGLE
FIGURE 1 - ADJUSTING/REPLACING FLIP-UP
FOOTBOARD
Wheelchair
Frame
WARNING
After ANY adjustments, repair or service and
BEFORE use, make sure all attaching hardware
is tightened securely - otherwise injury or dam-
age may result.
ALWAYS perform this procedure in the presence
of an assistant. The position of the footrest, cam-
ber tube, back angle, the tautness of the back
upholstery as well as the user's condition are di-
rectly related to the wheelchairs stability. Any
change to one (1) or any combination of the
five (5) may cause the wheelchair to decrease
in stability. Use EXTREME caution when using a
new seating position.
Check ALL Allen Screws that secure the foot-
rest/raised footrest system to the wheelchair
frame to make sure they are securely tight-
ened BEFORE using the wheelchair. ESPECIALLY
if engaging in ANY vigorous activity.
The footrest assembly MUST be at least 1-3/4-
inches above the ground/floor to avoid hitting
protruding objects when using this wheelchair.
ADJUSTING/REPLACING FLIP-UP
FOOTBOARD (FIGURE 1)
Adjusting Flip-Up Footboard
DEPTH.
1. Loosen the two (2) hex screws on each clamp
securing the footboard to the wheelchair.
2. Slide the footboard mounting bar to the desired
position.
3. Securely tighten the two (2) hex screws on each
clamp secureing the footboard to the wheelchair.
HEIGHT.
1. Remove the hex bolts, locknuts, and coved washers
seucring the footboard to the footboard mounting bar.
2. Reposition the footboard to the desired height.
3. Install the hex bolts, locknuts and coved washers
through the footboard and footboard mounting
bar as shown in FIGURE 1.